3D-POX is a two-component, solvent-free, kneadable epoxy. It is moldable, carvable, strong, and exhibits excellent adhesion to a variety of substrates. It is easily sanded and will accept paint, screws and nails.
Apply up to 20 mm thickness. Temperatures of the resin and the surface are to be between 18 and 25°C. Accurately weigh the components. Apply the resin manually or with a two-component mixing system. When mixing manually be careful not to mix in too many air bubbles. Pour the mixed components into a different container before use and mix thoroughly again.
Vacuuming is reccommended but not necessary.
Pour 3D Flex 55 into an aplicator (soft plastic bottle, injection syringe...) and slowly apply to the surface.
At least six months with temperatures between 15-25°C and protected from moisture.
Wear safety goggles and gloves. Work in a well ventilated area. &nbs
E paste is used for production of seamless models, contour shaped machinable blanks, mockups, composite toolings; good adhesion on expanded polystyrene and wood; good behavior on vertical supports up to 25 mm . Epaste