S25 Release agent 1l
RELEASE AGENT S 25
Mixes with water in all ratios
non-aggressive, non-corrosive to metal, plastic
great chemical resistance
excellent release ability
water resistant and well spreadable
temperature resistant to 250°C
applicable to hot and cold molds
Apply thorough thin coating over entire surface of model or mold.
• Allow surface solvents to evaporate for 5 minutes.
• Compressed air or hair dryer may be used to blow off any excess that has pooled.
• Repeat application and allow to dry.
• You are now ready to apply mold rubber or cast into a cured rubber mold.
Boiling point: 100°C
Flash point: 301°C
Density: at 20°C 0,9850 - 0,9950 g/cm³
Viscosity: at 20°C 6000 - 8000 mPa.s
Rubber industry, shoe making industry, cable production, asphalt processing, hydrophobe in glass industry, printing industry, aluminium, bronze casting, thermoplastics, epoxy, polyurethane, acrylic resin processing...