Naziv vsebine
V1 Release agent 750 g
RELEASE AGENT V-1
Apply thorough thin coating over entire surface of model or mold.
• Allow surface solvents to evaporate for 5 minutes.
• Compressed air or hair dryer may be used to blow off any excess that has pooled.
• Repeat application FOR 2-4 times and allow to dry.
• You are now ready to apply mold rubber or cast into a cured rubber mold.
Combine with PVA Release agent for polyesther resins.
DANGEROUS
H226 Flammable liquid and vapour.
P240 Ground the container and equipment for receiving the liquid and equalize potentials.
P241 Use [electrical equipment/ventilation equipment/lighting equipment/…] that is explosion-proof.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P303 + P361 + P353 IN CASE OF CONTACT WITH SKIN (or hair): Immediately remove all contaminated clothing. Rinse skin with water [or shower].
P501 Dispose of contents/container in accordance with regulations.
Related products
